How To Clean Salt Cell Pentair. Assuming you water isn't in the 50s, or colder, the first step is to. The following steps will provide a guide on how to recalibrate a pentair intellichlor.

Compu Pool Salt Water Chlorination System 30K, CPSC24
Compu Pool Salt Water Chlorination System 30K, CPSC24 from www.poolsinc.com

Once you have the power off, take the salt cell out to inspect it more closely. Other brands (jandy/ zodiac & goldline/ hayward) generator cells are a little different but are very similar on the inside as they all have electrode blades which convert the salt into chlorine. In a nutshell, the saltwater cell uses a small current of electricity to turn salt in the water into hypochlorous acid, which in turn sanitizes your pool water.

In many cases, saltwater cells need to be cleaned at least twice a year, but that may vary depending on pool size, usage, and other.

If this is the case, the salt level on the cell will need to be recalibrated. Once you have the power off, take the salt cell out to inspect it more closely. A number of things can cause that, cold water, calcium scaling, oils accumulating on the cell plates, or a defective cell.

Turn off the system pump and unscrew the unions on each end of the intellichlor cell.

You should be able to inspect. If necessary, you can use a wrench to loosen the old salt cell. Assuming you water isn't in the 50s, or colder, the first step is to.

But only tighten the new one by.

How to clean salt cell pentair. Test the salt level in the pool using an independent testing method. Fill a bucket with 1 gallon of tap water.

Cleaning the cell isn’t difficult, but replacing one is even easier.

Manually test the salt level with salt test strips or an electronic salt tester. Other brands (jandy/ zodiac & goldline/ hayward) generator cells are a little different but are very similar on the inside as they all have electrode blades which convert the salt into chlorine. Immerse the cell to the top of the wiring.

The solution can remove all sorts of remaining debris within a fortnight.

Manufacturers will most likely advise you to remove, clean, and store the unit indoors to avoid any damage. If the intellichlor has been in operation for a few weeks, remove and acid clean the salt cell before field recalibrating. The pentair ic40 manual recommends cleaning the cell with a garden hose nozzle at jet setting and knocking the loose calcium off.