f836b2fb228c817af5eb468b13cf192e
, ,

How To Install Roof Flashing Against A Stucco Wall

How To Install Roof Flashing Against A Stucco Wall. Use a good quality caulking like osi or vulkem, and you shouldn't have any problems with cracking. If the stucco has not been installed then the flashing should be underneath the stucco.

Roof to Wall Flashing
Roof to Wall Flashing from www.roofkey.com

After tearing up the old roof, we noticed that there is a bit of damage which resides along the area where the roof meets a stucco wall, i am told that i should use some sort of flashing. Apply the roofing felt and nail the first piece of step flashing to the lowest point where the roof meets the wall as shown in. When planning your metal roofing project, if you have metal roofing panels that are running up into a wall, you’re going to need to install endwall to help control where water flows to protect your structure.

In addition, they recommend screwing the flashing to the wall, which seems to be the only effective way of getting a good seal.

Certain parts of the flashing, such as counter flashing and ez bead, are installed prior to the stucco application and then patched back in after the installation is complete. Remove the flashing and apply some roofing cement to fix the flashing into place. Use a good quality caulking like osi or vulkem, and you shouldn't have any problems with cracking.

But i reckon sealing the end of the vertical metal surface to the wall using flashing tape should still work pretty well.

If the stucco is already in place then the flashing must rest against the stucco in a similar manner to that of a brick wall. Metal roof flashing can be use to seal gaps between roof walls. The other quick, cowboyish alternative is to use flashing tape to seal the box profile against.

When planning your metal roofing project, if you have metal roofing panels that are running up into a wall, you’re going to need to install endwall to help control where water flows to protect your structure.

The flashing extends up the wall at least 4. How to install roof flashing against a stucco wall. If the stucco has not been installed then the flashing should be underneath the stucco.

Since the roof is fairly old, when it was originally built, there wasn't any flashing installed since the materials were not available at the time.

Install sidewall trim prior to the installation of the endwall flashing The flashing needs to be installed before installing the roof shingles. Lay 2×4 blocks on the roof to set a consistent height for the weep screed flashing.

Flash onto the surface of the existing stucco.

After tearing up the old roof, we noticed that there is a bit of damage which resides along the area where the roof meets a stucco wall, i am told that i should use some sort of flashing. After you have gathered all your materials, you will lay roofing felt over the area that will have flashing. If the stucco is already in place then the flashing must rest against the stucco in a similar manner to that of a brick wall.

Leave a Reply

Your email address will not be published. Required fields are marked *